ARC TCD Commissioning Instructions

The only communications device you'll need. The same TCD can be used with Grade 2, 3 and 4 EN signalling and connects to the control panel via pins, serial connections or dial capture.  With the option of monitoring in 3 combinations to ensure all signalling requirements are covered.

• IP & GPRS
• GPRS & PSTN
• IP & PSTN
• IP Single Path

The TCD can be used with dynamic and static IP addressing and, because it uses TCP/IP outbound communications only, it does not interfere with the inbound firewall security settings. 

Any problems and our 24/7 technical desk is there to help - 0844 412 9009

The TCD establishes secure 'always on' IP connections to the Monitoring Centre using broadband/IP as the primary fixed or wired network, and GPRS as the secondary wireless path. Both paths are fully managed across the Emizon Service Platform. With the GPRS and PSTN option, GPRS is used as the primary and PSTN as the secondary path.  Again both paths are managed across the Emizon Service Platform. Finally with the IP and PSTN option, the broadband/IP is the primary or wired network and PSTN the secondary path.

 

 

PDF downloads to explain how to successfully install an Emizon TCD can be downloaded from here;

The Quick Start Guide which is included in every TCD box   -   TCD Quick Start Guide 

Complete TCD Installation Guide   -   TCD Installation Guide